Publicidad
Idiomas disponibles
Idiomas disponibles
To start the product
To do before you start the product
WARNING:
product, carefully read and understand
the safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
check of the engine oil level on page 27 .
2. Fill the fuel tank with fuel. Refer to
page 12 .
3. Disengage the freewheel mode. Refer to
product in freewheel mode on page 17 .
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
disengage the parking brake on page 15 .
6. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 16 .
To start a warm engine
1. Sit in the seat.
2. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 16 .
3. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 14 .
4. Move throttle control to fast position.
5. Pull out the choke control.
Note:
For a warm engine start, it may not be
necessary to use the choke control.
6. Push down on the brake pedal fully and keep it
pushed down.
7. Put the ignition key into the ignition.
8. Turn the ignition key to the "START" position and
release the ignition key when the engine starts.
CAUTION:
starter continuously for more than 15
seconds for each minute.
9. When the engine has started, slowly push in
the choke control until the engine runs smoothly.
When the engine operates smoothly, the attached
equipment can be operated and you can operate the
forward and rearward drive.
Note:
If the engine runs roughly, pull the choke
control out for a few seconds and then continue to
push the choke control in slowly.
2235 - 002 - 22.09.2023
Before you operate the
To do a
To fill fuel on
To put the
To engage and
Do not operate the
Note:
If the engine does not accept the load,
restart the engine and let it warm up for one minute.
Follow the instructions above.
To start a cold engine
1. Sit in the seat.
2. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 16 .
3. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 14 .
4. Move the throttle control to the middle throttle
position.
5. Pull out the choke control.
6. Push down on the brake pedal fully and keep it
pushed down.
7. Put the ignition key into the ignition.
8. Turn the ignition key to the "START" position and
release the ignition key when the engine starts.
CAUTION:
starter continuously for more than 15
seconds for each minute.
Note:
If the engine does not start after some tries,
push the choke control in and wait some minutes
before you try again.
9. When the engine starts, move the throttle control
to the fast position to warm up the engine. If the
temperature is low, some minutes is necessary for
the engine to get warm.
CAUTION:
temperature is less than 40° F (4° C),
you must let the engine operate 1 minute
at idle speed before you operate the
product. This is to let the transmission
warm up. Make sure that the brake pedal
is fully released.
10. Push in the choke control slowly.
Do not operate the
If the ambient
13
Publicidad
