Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove the nut, the bolt, the washer, and the anti-
scalp roller.
3/4"
4. Install the anti-scalp roller, the bolt, the washer, and
the nut in the correct position.
5. Adjust all anti-scalp rollers and install them in the
same procedure.
Engine
To lubricate the engine
Only use high quality detergent oil rated with API service
classification SJ-SN. The oil's SAE viscosity grade
refers to the correct temperature for operation.
5W-30
-20
0
30
F
C
-20
-30
-10
Note:
Multi-viscosity oils (5W30, 10W30, and so on)
help the engine start easily in cold weather but causes
increased oil use when used in temperatures above
32°F/0°C. Do a check of your engine oil level frequently
to prevent possible engine damage caused by low oil
level.
•
Change the oil after intervals of 50 hours of
operation. If the product is not used for 50 hours in a
year, change the oil at a minimum of 1 time a year.
•
Do a check of the crankcase oil level before you
start the engine and after each eight (8) hours of
operation.
•
Tighten the oil fill cap/dipstick each time you do a
check of the oil level.
To do a check of the engine oil level
The engine in the product is filled with engine oil for
ambient temperatures of more than 32° F (0° C). For
operation in ambient temperatures of less than 32° F (0°
C), use the correct engine oil to make the product easier
to start. Refer to .
1. Park the product in level ground.
2235 - 002 - 22.09.2023
9/16"
SAE 30
32
40
60
80
0
10
20
30
2. Remove the oil fill cap and dipstick and clean it with
a cloth.
3. Put the dipstick into the oil fill tube. Do not turn the
oil fill cap onto the oil fill tube.
4. Remove the dipstick. Use the gauge on the dipstick
to examine the engine oil level. If necessary, fill
engine oil until the mark "FULL" on the dipstick is
reached. Do not fill too much engine oil.
ADD
5. Put the dipstick into the oil fill tube. Make sure that
the oil fill cap is fully tightened.
Note:
To replace the engine oil, Refer to
the engine oil on page 27 .
To change the engine oil
Note:
All oil must meet API service classification SJ-
SN.
Note:
Oil drains more freely when the engine is warm.
Make sure the product is on a level surface before you
chain the engine oil. Set the possible temperature range
100
before the oil change.
40
Collect the oil in an applicable container.
1. Lift the hood.
2. Remove the fastener (A) from the lower dash cover
(B).
B
A
3. Move the lower dash cover (B) to release the cover
tabs (C) from the tapered slots (D) in the lower dash
cover (B) and then remove.
4. Remove the oil fill cap and dipstick.
CAUTION - DO
FULL
C
CAUTION:
Remove the lower dash
cover (A) carefully to make sure the
cover tabs (C) are not broken.
01341
To change
D
27
Publicidad
