Publicidad
Idiomas disponibles
Idiomas disponibles
▶ Inserting and Removing Bits
(Drill Chuck)
Move forward/reversing lever 6 to the cen-
ter "OFF" position. Remove battery pack 5
and rotate the clutch ring 2 to the drill bit
symbol
. Rotate the chuck sleeve 11a
counter-clockwise viewing from chuck end,
and open chuck to approximate drill bit di-
ameter. Insert a clean bit up to the drill bit
flutes for small bits, or as far as it will go
for large bits. Close chuck by rotating the
chuck sleeve 11a clockwise and securely
tighten by hand (Fig. 9).
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to
grasp the spinning chuck.
▶ Belt Clip and Bit Tip Holder
Bosch GSR12V-300FC comes with the op-
tion to use a metal belt clip and a four piece
bit tip holder. Pry off the plastic cover 16
from the back of the drill to install these ac-
cessories (Fig. 10).
▼ BELT CLIP
tion yourself to avoid entanglement with
surrounding objects. Unexpected entangle-
ment could cause the tool to fall resulting in
injury to the operator or bystanders.
The belt clip will allow you to conveniently
attach your tool to your belt. This feature
will allow you to have both hands free when
climbing a ladder or moving to another work
area.
The belt clip 17 can be positioned on either
side of the tool and secured to the back of
the tool with a mounting screw (Fig. 11).
Always make sure you securely tighten the
mounting screw before use.
12
2610051918.indd 12
Assembly
Do not use the power of
the drill while grasping
When the tool is at-
tached to the belt, posi-
Fig. 9
To use clip, turn tool upside down and at-
tach to your belt.
11a
2
Fig. 10
16
6/11/19 2:10 PM
Publicidad
