Astoria Core600 AL Manual De Uso Y Mantenimiento página 69

8.1.3 Programming the cup warmer
To adjust the cup warmer temperature, proceed as
follows using the right-hand side push button panel:
When the machine is turned on, wait for all of the
button LEDs to come on and then immediately press
the button: the flashing LED will indicate the
current configuration of the cup warmer, as shown in
the diagrams below;
Hold down the
panel goes from a flashing to a steady light;
Press the key that corresponds to the desired con-
figuration;
Confirm the operation by switching the machine off
and back on.
60°C
90°C
Cup warmer
8.1.4 Programming the standby
To put the machine in standby mode, i.e. switch it off
whilst keeping the push button panel active, proceed
as follows:
Press the button on the right-hand side
push button panel and the
afterwards;
The machine is in standby mode when the
button's LED flashes;
To exit the standby mode, press the
USER manual
button until the LED on the
70°C 80°C
110°C
100°C
button immediately
button.
DISPLAY version
8.2
8.2.1 Programming the coffee dispenses
The machine is programmed by default. Should the
coffee doses need to be modified, proceed as follows:
Always programme the right hand push-button panel
first. In this way all push-button panels get automati-
cally programmed. If necessary,
subsequently programme the
others;
Place the cup under the dis-
pensing spout;
Press the button for at
least 5 seconds, until all the dose
button LEDs are lit;
Press the desired dose button,
for example ;
To confirm the dose, press
the button again or the
button;
Repeat this operation for the
other dose buttons;
When the programming is com-
plete, press the
until all of the LEDs on the push
button panel go off.
Programming of every dose must be carried out with ground coffee
and not with previously used coffee dregs.
Core600
button
69 300
of