Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed
[] 200 mm (8") or 250 mm
[]
8 mm (sA0")socket wrench
(10") Pipe wrench
[]
Utility knife
[] 200 mm (8") or 250 mm
[] Vent clamps
(10") adjustable wrench
[]
Sealing compound
gun
[]
Flat-blade screwdriver
and sealing compound
[]
Phillips screwdriver
(for installing new
[] Adjustable
wrench that
exhaust vent)
opens to 2.5 cm (1") or
[]
Pliers
hex-head socket wrench
[]
Putty knife
[]
Level
Parts supplied
Remove parts bag from dryer drum. Check that all parts were
included.
[]
Foot boot (4)
[]
Dryer foot (4)
NOTE: The circuit diagram for this machine is located inside the
lower front panel.
Explosion Hazard
Keep fiammab{e
materials
and vapors, such as petrol,
away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion, or fire.
IMPORTANT: Observe all governing codes and ordinances.
[]
Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages or sleeping quarters.
Contact your local building inspector.
[]
Do not install on carpet.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.
Recessed
Area Installation
Instructions
This dryer may be installed in a recessed area.
This dryer must not be installed in a closet with a door.
The installation spacing is in mm and is the minimum allowable.
Additional spacing should be considered for ease of installation,
servicing, and compliance with local codes and ordinances.
The dryer must be exhausted outdoors.
No fuel-burning appliance may be installed in the same recess
as the dryer.
Minimum Installation
Clearances
Back
Sides
Top
{
Front
I
IRecessed{51
mm {
0mm
[ 305mm
[
--
{
(2")
(0")
(12")
-_1 j_-51
mm
(2")_ _
3o5 mm
(12")
O
O
r-"l:::
[z3
0 II
(0 mm)
0 mm (0")--_l
I _ _-
___l'-i__l,
0" (0 mm)
Recessed
Recessed
side view
front view
Additional clearances for wall, door, and floor moldings may be required
or if external exhaust elbow is used.
Publicidad
