Publicidad
Idiomas disponibles
Idiomas disponibles
Each vent s hould e nter themain vent a tanangle pointing i nthe
direction oftheairflow. Vents e ntering from theopposite side
should b estaggered toreduce t heexhausted airfrom interfering
with theother v ents.
The maximum a ngle ofeach vent e ntering themain vent s hould
benomore than 30 °
.
A
A. Individual dryer vent
B. Main vent
Keep air openings free of dry cleaning fluid fumes. Fumes create
acids which, when drawn through the dryer heating units, can
damage dryers and loads being dried.
A clean-out cover should be located on the main vent for periodic
cleaning of the vent system.
If an exhaust hood cannot be used:
i
Min. 300 mm (12") clearance
above any accumulation
of snow,
ice, or debris
such
as leaves.
A. Exhaust hood or elbow
B. Waft
C. Main collector vent
D. Horizontal vent
E. 180° sweep elbow
E Vertical vent
G. Roof
610 mm (24")
min, above
highest point
of building
G
............... C
The outside end of the main vent should have a sweep elbow
directed downward. If the main vent travels vertically through the
roof, rather than through the wall, install a 180° sweep elbow on
the end of the vent at least 610 mm (2 ft.) above the highest part
of the building. The opening in wall or roof shall have a diameter
13 mm (W') larger than the vent diameter. The vent should be
centered in the opening.
Do not install screening or cap over the end of the vent.
Use caulking compound
to seat exterior wall opening around
exhaust vent.
INSTALLATION INSTRUCTIONS- E LECTRICDRYER
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
NOTE: Slide dryer onto cardboard or hardboard before moving to
avoid damaging floor covering.
1. Using two or more people, move dryer to desired installation
location.
2. Take tape off front corners of dryer. Open dryer and remove
the literature and parts packages. Wipe the interior of the
drum thoroughly with a damp cloth.
3. Take two of the cardboard corners from the carton and place
them on the floor in back of the dryer. Firmly grasp the body
of the dryer and gently lay it on its back on the cardboard
corners.
4. With one of the legs in hand, check the ridges for a
diamond marking. That's how far the leg is supposed
to go into the hole.
5. Start to screw the leveling legs into the holes by hand.
(Use a small amount of liquid detergent to lubricate the screw
threads so it is easier to turn the legs.) Use a 25 mm (1")
wrench or socket wrench to finish turning the begsuntit you
reach the diamond mark. Then fit a protective foot boot over
each foot.
Now stand the dryer up.
6. Remove cardboard or hardboard from under dryer. Adjust the
legs of the dryer up or down until the dryer is level.
7
Publicidad
