Hitachi Koki C 18DL Manual De Instrucciones página 17

Wood
2 × 8 (Spruce-Pine-Fir)
Concreteform plywood
(1/2" (12 mm) t)
To improve working efficiency per single charge,
Minimize operation (no-load operation) other than
cutting;
Avoid any unreasonably forced pressure to the
motor during cutting operation by twisting or
pressing the circular saw forcibly;
Avoid any use of dull saw blade.
3. Cutting procedures
CAUTION:
Recheck that the saw blade is securely clamped.
Confirm that the wing-nut for adjusting the slot
depth, the wing-bolt for adjusting the angle of
inclination.
(1) Place the base on the material, then align the
premarked line and the saw blade with the notch
at the front of the base (Fig. 12).
(2) When the base is not inclined, use the large notch
(Fig. 12, Fig. 13).
If the base is inclined (45 degrees), use the small
notch (Fig. 12, Fig. 14).
Not inclined
Saw blade
Fig. 12 <Top View>
Capacity
Battery (EBM1830) Battery (BCL1815)
110 cuts 55 cuts
133 ft (40 m) 67 ft (20 m)
Wing-bolt
Fig. 13 Not inclined
Inclined
gauge
Wing-bolt
NOTE:
When using the saw at the inclination of 45
degrees, use both the marks of on the bevel plate
and [45] on the inclined gauge of the base (Fig.
15).
What's more, if it is absolutely essential to use the
saw at a precise angle, make adjustment using a
protractor, etc.
Bevel plate
Inclined
gauge
English
Guide
Cutting line
(at 45 degrees)
Fig. 14
Wing-bolt
Fig. 15
17