Next Level Racing ERS3 Manual Del Usuario página 13

19
Align the mounting slots on the Seat Brackets with the T-Nuts previously installed in Step 17. Bolt
through and secure with 4 x M8 Bolts and Washers.
A)
A) Lift the Seat Slider Lever and slide the Seat Rails all the way back to access the rear mounting slots
20
on the Seat Slider.
B) Align the Seat Slider rear mounting slots with the T-Nuts in the rear 4040 Extrusion that was
uninstalled in Step 13. Secure it to the Seat Sliders using M8 Low Profile Bolts.
A)
A) Lift the Seat Slider Lever and slide the Seat Rails all the way forward to access the front mounting
21
holes on the Seat Slider.
B) Align the Seat Slider front mounting holes with the T-Nuts in the front 4040 Extrusion that was
uninstalled in Step 13. Secure it to the Seat Sliders using M8 Low Profile Bolts.
NOTE: Leave Bolts hand tight to allow
adjustment in future steps.
B)
B)
Video Instruction: bit.ly/nlrbuild
NOTE: Partially tighten bolts
with fingers, then secure using
M6 Allen Key.
Repeat
on Other
Side
NOTE: Partially tighten bolts
with fingers, then secure using
M6 Allen Key.
Repeat
on Other
Side
13 13
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • 2 x Side Mount Seat Brackets
PARTS:
• • 1 x Rear 4040 Extrusion
• • 2 x M8 16mm Low Profile Bolts
• • 2 x M8 Spring Washers
Note: Use Spring Washers with M8
Low Profile Bolts when installing
Seat to the F-GT Elite Cockpit.
PARTS:
• • 1 x Front 4040 Extrusion
• • 2 x M8 16mm Low Profile Bolts
• • 2 x M8 Spring Washers
Note: Use Spring Washers with M8
Low Profile Bolts when installing
Seat to the F-GT Elite Cockpit.