Panasonic EYADA Serie Manual De Instrucciones página 15

Attaching Grip Attachment
The grip attachment can be attached to
all models.
(Supplied for EYADA407XC only)
It can absorb the reactive force during
clutch activation, which helps reduce
fatigue.
Use in lever start mode
Align grooves in the grip
attachment with ribs on the grip.
④
③
①
⑥
Use in push start mode
Align grooves in the grip
attachment with ribs on the grip.
③
⑥
①
④
EYADA_EU.indb EYADA_EU.indb 15 15
Components of the attachment
① Grip attachment (A) x 1
② Grip attachment (B) x 1
③ Trigger x 1
④ Joint x 1
⑤ Screw x 7
⑥ Spring x 1
ATTENTION
⿟ When attaching or removing the
grip attachment, set the forward/
reverse lever to the "○ (Trigger
switch locked)" position, and turn
⑤
OFF the power switch of the power
adapter.
⿟ Remove the bit before attaching or
removing the grip attachment.
⿟ After fixing the grip attachment
with screws, check for any loose
screws, backlash, or misalignment.
②
⑤
Screwdriver hanger mounting hole (x 2)
②
P. 13, 16
Align grooves in the grip
attachment (A) with ribs on
the tool grip.
Attach the trigger and the
joint to the positions shown
in the figure.
Align grooves in the grip
attachment (B) with ribs on
the tool grip.
Fasten the screws.
Check for any loose screws,
backlash, or misalignment.
15
EN
2023/11/01 2023/11/01 16:44:22 16:44:22