5.3
Recommended nozzles
The burner complies with the emission requirements of the EN
267 standard.
In order to guarantee that emissions do not vary, recommended
and/or alternative nozzles specified by manufacturer in the In-
struction and warning booklet should be used.
It is advisable to replace nozzles every year dur-
ing regular maintenance operations.
WARNING
Burners RG2
Steinen
type S - Q;
Danfoss
type S - B;
Delavan
type B - W;
Monarch type R.
For nozzles of 1.75 - 2.00 - 2.25 GPH, it is advisable to use full
cones.
Burner RG3
Steinen
type S - Q;
Danfoss
type S - B;
Delavan
type B - W;
Monarch type R.
For 3.00 - 3.50 GPH nozzles, preferably use full cones.
The use of nozzles other than those specified by
manufacturer and inadequate regular mainte-
nance may result into emission limits non-con-
forming to the values set forth by the regulations
in force, and in extremely serious cases, into po-
tential hazards to people and objects.
CAUTION
The manufacturing company shall not be liable for
any such damage arising from non-observance of
the requirements contained in this manual.
20136866
Start-up, calibration and operation of the burner
22
GB