Beper CLICK&CLACK P206VEN102 Manual De Instrucciones página 11

Click&Clack Stand Fan Use Instructions
Children should not play with this appliance.
Cleaning and maintenance should not be performed by children
without supervision.
For the safety of children and pets, remove and dispose of all
packaging materials before use.
This fan is intended for exclusive domestic use, as described in
this manual. Any other use is considered improper and, therefore,
dangerous.
Item Description Fig.A
1. Scratch-resistant Rubber Pads
2. Base Feet
3. Base Center
4. Outer Pole
5. Height Adjustment Knob
6. Inner Tube
7. Motor Body Lock
8. Motor Body
9. Control Panel
10. Oscillation Pin
Instructions Fig.A-B
Important: Ensure that the base feet are securely attached to the Base Center to guarantee proper
stability.
Otherwise, the fan may oscillate dangerously. If the inner tube is not visible, it might be fully inserted into
the outer tube. Loosen the Height adjustment knob and pull it out to the desired height. Tighten the height
adjustment knob to secure the desired height.
Operation Fig. A
Select the fan speed by pressing the appropriate button on the Control Panel. You can adjust the tilt of the
head to change the direction of the airflow by rotating the motor body head. A slight "click" will be heard at
each tilt level.
Note: There is no need to turn any screws to adjust the tilt of the head.
Caution, Tilt the head only when the fan is turned off. To activate automatic oscillation, press the
rotation pin downward, as shown in fig. A; pull it gently upward to deactivate oscillation.
Cleaning
Before performing any cleaning operation, turn off the fan and disconnect the plug from the power outlet.
Use a soft cloth, possibly dampened with water, to clean the fan. Do not use alcohol or chemical agents such
as thinners or abrasive products. Avoid spraying water and liquids on the fan to prevent harmful infiltrations.
Thoroughly dry all cleaned parts before turning on the fan. When not in use during the winter season, store
the fan in a dry and clean place.
Technical Data
Power: 40W
Power supply: 220-240V~ 50Hz
For any improvement reasons, beper reserves the right to modify or improve the product without any
notice
11. Motor Shaft
12. Back Grid
13. Back Grid Lock
14. Fan
15. Fan Lock
16. Front Grid
17. Locking Hooks
18. Safety Screws
19. Safety Nut
11
EN