Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1
DESCRIPTION
1.1
PURPOSE
The product fitted with a cutting attachment mounted
on a pole to enable the operator to cut the branches
of standing trees but not intends for cutting woods as
normal chainsaw.
This appliance is not intended for use by persons
(including children) with reduced understanding, or lack
of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
1.2
OVERVIEW
Figure 1-20
Lock-out button
1
Trigger
2
Scabbard
3
Pole saw handle
4
Collar
5
Extension pole
6
Pole saw head
7
Chain cover lock
8
nut
Oil tank cap
9
10 Bar
2
GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3
INSTALLATION
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
11 Chain
12 Oil indicator
13 Chain lubricant
14 Chain cover
15 Shoulder strap
16 Battery pack
17 Battery release
button
18 Sprocket
19 Chain tension pin
hole
WARNING
WARNING
English
•
If parts of the machine are damaged, do not use
the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
3.2
ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level
is low, add the bar and chain lubricant as follows.
Use bar and chain lubricant that is only for chains and
chain oilers.
The machine comes from the factory without bar and
chain lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt
enters in the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. A completely filled oil tank will last for 15 - 40
minutes operating time.
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
3.3
ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 10-14.
1. Remove the battery pack from the machine.
2. Remove the chain cover nuts with the wrench.
3. Remove the chain cover.
4. Put the chain drive links into the bar groove.
5. Put the chain cutters in the direction of the chain
operation.
4
WARNING
IMPORTANT
NOTE
IMPORTANT
Publicidad
