Publicidad
Idiomas disponibles
Idiomas disponibles
Rip and Cross Cutting
NOTE: The cutting line of saw blade
is aligned with the cutting mark 0°.
Using the Laser Light Feature
Replacing Laser Batteries
Parallel Guide
Adjusting the Cutting Depth
Adjusting the Cutting Angle
NOTE: The cutting line of saw blade
is aligned with the cutting mark 45°.
Pocket cutting
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
14
14
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and
the tooth count of the saw blade. Therefore, use only
sharp saw blades that are suited for the material being
cut.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board,
etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically and
if damaged, have repaired by authorized service facility.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base to
ensure proper performance.
Compact Circular Saw With Laser
TROUBLESHOOTING
See Fig. C1, C2
Symptom
See Fig. D1, D2
See Fig.E1,
E2,E3
See Fig. F1, F2
See Fig. G1, G2
Tool will not
start when
operating the
See Fig. H
on/off switch.
See Fig. I1, I2
See Fig. J
Cutting depth
is less than
that is set.
Blade spins or
slips
Blade will not
cut a straight
line.
Blade kicks
back when
beginning
a cut
Possible
Possible Solution
Causes
Power cord not
Check to make
plugged in.
sure power cord is
connected well into
Power cord is
a working outlet.
broken.
Unplug the power
cord. Replace it
Carbon brush
using a qualified
has worn down
maintenance
person.
Replace the
carbon brush
using a qualified
maintenance
person.
Shake out
Sawdust
sawdust. Consider
accumulated
connecting a
at the rear of
vacuum for dust
the base.
collection.
Blade is
Remove the blade,
not tightly
and reassembled
engaged with
it as described in
MOUNTING AND
the spindle.
REMOVING THE
BLADE section.
Blade is dull.
Mount a new, sharp
Blade is not
blade on the saw.
mounted
Check that blade is
properly.
properly mounted.
Saw is not
Use and edge
being guided
guide.
properly.
Blade is not
Allow the saw blade
spinning fast
to reach full speed
enough
prior to beginning
a cut
EN
Publicidad
