BWT Inverter Connect IC 68 Manual De Instrucciones página 26

4.1 Wired remote control
REGULATION (ELECTRONIC CONTROLLER)
Operating mode
Set temperature
Set temperature
Water temperature
Water temperature
Parameters
Start-up and Locking
Press 3 s to unlock the control box.
Before you start, make sure the filtration pump is running and that water is flowing through the
Press 2s to turn the heat pump on or off. This button is also used to return to the main interface.
heat pump.
The lock activates automatically after 60 seconds of inactivity). When the cabinet is locked, the logo
Before setting your set temperature, you must choose the operating mode of your heat pump first
Operating Modes
Press the button to change the operating mode:
Other indications of the control box
Then press to change the operating mode press
again to validate the change and return to the main
menu.
Heating
SILENT Heating mode:
that the heat pump operates silently.
Auto
ECO Heating mode:
heat pump to operate in a conventional manner
MAX heating mode:
Cooling
the heat pump quickly heats the water in your pool.
Auto mode: The heat pump intelligently chooses the most
Defrosting
appropriate operating mode according to the setpoint temperature.
SILENT Cooling mode:
the heat pump to operate silently.
WiFi
ECO Cooling mode:
the heat pump operates in a conventional manner.
MAX Cooling mode:
heat pump to operate in a classic way.
Heating
Auto
Cooling
Clock
Lock
Failure
Set temp
Clock
Choose this heating mode so
Current time
Choose this heating mode for the
Choose this heating mode so that
Timer On/Off
Mode compressor
speed
Choose this cooling mode for
Parameters
Choose this cooling mode so that
Choose this cooling mode for the
Current time
Clock
Button On/Off
Button: On / Off
Setting the required temperature
Water inlet temp.
Set temp.
Clock setting
Value
Humidity unit
pressing .
Lock
Step 4: Change hours/minutes by using
18
Step 5: Press the button
return to the main menu.
Defrosting
Deforsting
WiFi
Timer On/Off
Compressor speed
mode
Water inlet temp
Compressor
Fan
Water Pump
appears
Step 1: Go to the main menu by
unlocking the control panel.
Step 2: Press the and
to change the set temperature.
Failure
Compressor
Step 1: Go to the main menu by
unlocking the control panel.
Fan
Step 2: Press 2 times to enter
the clock setting interface. The clock
display flashes.
Water pump
Step 3: Press
to switch from
hours to minutes and validate by
and
1s to confirm the setting and
buttons
.