Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
STORING THE SNOW BLOWER
CAUTION
may drip from the snow blower is properly wiped up to
prevent a slip and fall hazard.
z Wipe the snow blower with a clean dry cloth.
z Check all nuts, bolts, knobs, screws, fasteners, etc., for
tightness.
REPLACEMENT PARTS
The following replacement parts are available by contacting Westinghouse customer service toll-free at 1 (855) 944-3571.
18-in. Auger ..................................................................................................................................................AAAC011013
18-in. Belt .....................................................................................................................................................AAAC011016
18-in. Scraper ...............................................................................................................................................AAAC011036
TROUBLESHOOTING
PROBLEM
Snow blower won't
start
The motor is on but the
auger does not turn.
A layer of snow
remains on the ground
after passing over it.
Make sure all melted snow that
POSSIBLE CAUSE
Snow blower is not plugged in.
The start button was not depressed.
The drive belt may be worn or broken.
The auger or scraper may be worn.
z Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.
z Loosen the handle knobs and lower the upper handle
assembly.
z Store snow blower indoors in a clean, dry place out of
the reach of children.
z Do not store near corrosive materials such as fertilizer
or rock salt.
CORRECTION
Connect snow blower to 120V power
supply. Be sure the snow blower plug is
properly connected to the extension cord.
Press and hold the start button before
engaging the bale.
Replace the drive belt.
Have the auger or scraper replaced by an
authorized service center.
English
|
15
Publicidad
