LauraStar Go+ Puesta En Marcha Rapida página 5

F
Advice
For mohair, cashmere, velvet, angora : do not allow the fabric to come
into contact with the protective soleplate (8). Iron the fabric at a
distance of approximately 10 cm / 4 in while diffusing steam, so that
the fabric does not become felted. Then take the item of clothing in your
hand and shake it to restore its volume.
For velvet, corduroy and jersey, we recommend steaming without the
protective soleplate (8) at around 2-3 cm / 1-2 in from the fabric, then
levelling out by hand.
G
Vertical smoothing out
Suspend the item of clothing on a hanger. Moving the appliance from
top to bottom, lightly touch the fabric using short bursts of steam.
Note : almost all fabrics smooth out easily, with the exception of cotton,
linen and certain silks. If a fabric is difficult to smooth out, place it on
the ironing board and iron it normally.
WARNING : Do not iron or vertical steam clothes that are
being worn. Do not point vertical steam in the direction
of people or pets.
Filling
DANGER : this appliance produces PRESSURIZED
STEAM. Contact with pressurized steam can cause
serious burns. SWITCH OFF and UNPLUG the appliance before
filling or draining the iron. Switch off and unplug the appliance
A
when not in use.
Low water indicator light (16) and audible alarm
A warning tone sounds and the low water indicator light (16) flashes to
signal that there is no water left in the steam generator's reservoir.
When the alarm sounds, you have 3 minutes before the system
switches off automatically. However, there is enough steam to finish
the garment you are in the middle of ironing.
B
Filling the steam generator
• Press the STEAM button (10) and hold down until any residual
steam has been fully released.
C
• SWITCH OFF the appliance and DISCONNECT the plug (19) from the
outlet.
C
F
G
B
- 7 -
A
A
C
• SLOWLY unscrew the filling cap (17) (using a cloth to avoid any direct
contact with the steam) until you hear or see the steam escaping -
about 2 turns - and wait until steam has been fully released.
DANGER : Contact with pressurized steam can cause
D
serious burns. Step back from the appliance when
unscrewing and removing the filling cap. Pressurized
steam will escape.
• Unscrew the cap fully and remove. Fill the bottle supplied (12) with
water and place the nozzle of the bottle in the opening in the steam
generator. Squeeze the bottle briefly. Once full, carefully screw the
filling cap back on (17).
E
• To continue ironing, plug in and switch on your appliance again.
E
Maintenance
To prolong the life of your appliance, we recommend that you
clean your iron every month or after every 10 hours of ironing.
WARNING : the appliance should be UNPLUGGED, OFF
and COLD before cleaning. Switch off and unplug the
appliance. Allow your appliance to cool down for at least
2 hours. Always make sure your appliance is cold before
cleaning !
NOTICE ! Only rinse the appliance with water. NEVER use
descaling products or other chemical products.
B
Cleaning the iron (2)
If the iron's soleplate is dirty, use a Laurastar cleaning mat in
accordance with the instructions. Cleaning mats can be obtained at
www.laurastar.com or from your approved Laurastar retailer.
Stubborn stains can be cleaned using an abrasive dishwashing sponge.
After completing this operation, remove the aluminium oxide present
under the soleplate by cleaning it with a damp cloth.
- 8 -
EN
D
A
B C