Publicidad
Idiomas disponibles
Idiomas disponibles
English
5. Installation
5.1 Prepare for installation
Make sure that the surface can support the
maximum weight of the automat, including
the water. Refer to chapter 9: Technical
specifications.
• The automat may not be affected by
external forces.
• No dirt may get into the automw at and its
accessories.
• Install shut-off devices to the drinking water
net on-site.
• Plan enough free space around the automat
for maintenance work.
• Note the effective regulations regarding
the use and the installation location and, if
necessary, inform the responsible testing
and certification bodies prior to the launch
of the system.
5.2 Ambient conditions
> 0 °C ... 40 °C (Tagus Vac 7)
< 80%
> 0,5 m
Make sure
• that the automat is level;
• that the automat is installed in a closed, dry
and frost-free room;
• to maintain the minimum distances as
indicated;
• that the atmosphere does not contain
electrically conducting gases or high
concentrations of dust and vapors. Risk of
explosion when there are combustible gases;
• that the vicinity is clean and well lit.
- Relative humidity: not condensating.
- Free of vibrations.
- Free from heat- and solar radiation.
• that the automat is free from additional
loads.
5.3 Hydraulic installation
40
45 °C (Tagus Vac 10-30)
> 0,5 m
> 0,5 m
• Install the shut-off devices on-site in front
of the tube joints.
• Only work on non-pressurised and cooled-
down pressure joints.
• Connect the supply line to the refilling
supply.
• If necessary, install a dirt trap at the drinking
water joint (0.2 mm).
• The minimum nominal diameter for the
installation line of the system and the supply
line is DN 20.
• Connect the return line of the system to the
inlet of the Tagus Vac 7-30.
03/2024
Publicidad
