MSW Motor Technics MSW-GDOOR-003B Manual De Instrucciones página 44

When the control board is working, the users can check working state of gate opener by digital screen
on the control board.
: no input;
: under opening state;
: under closing state;
:manual mode;
: travel setting;
5.4 Travel Setting (VERY IMPORTANT)
In the first installation of gate openers, the installer needs to set open and closed limit switch
positions for running the travel.
5.4.1 Learn the journey in the distress limit mode
Open both sides of the gate and lock the clutch, and then press and hold the "+" button on the control
board until the digital screen shows "SU". After this step, the gate will firstly run towards the closing
direction and stop, and then the gate will automatically open. When the two swing gates are fully
open, the gates will automatically close for the second time, and the travel setting will be completed
when the gates are closed. If the distance of starting slow speed of gate is not appropriate, adjust the
"SLOW DOWN " button to revise the distance.
Note:
Wiring: the black wire of main engine 1 is connected to the left side of MOTOR1; The brown

cable of host 1 connects to the right side of MOTOR1.The black cable of main engine 2 connects
to the left side of MOTOR2; The brown cable of main engine 2 connects to the right side of
MOTOR2.
In single-door mode, the host connects to MOTOR1.

If the gate suddenly stops during travel setting, please increase the resistance force.

If the gate didn't stop when meets the obstacles during travel setting, please appropriately

reduce the resistance force.
Installer must redo travel setting after modifying the "SPEED" trimmer.

EN