cecotec IRONHERO 2600 FORCE Manual De Instrucciones página 40

ENGLISH
5. TROUBLESHOOTING
Problem
Not enough or too much
heat.
No steam or leakage.
The steam-shot function
or vertical ironing does
not work properly.
Water leaks from the
soleplate.
Little steam.
Spray does not work
properly.
6. TECHNICAL SPECIFICATIONS
Product reference: 01867
Product: IronHero 2600 Force
2600W, 220-240V, 50/60Hz
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
40
IRONHERO 2600 FORCE
Possible cause
The temperature knob is not
in the right position, or the
appliance is switched off.
The temperature knob is set to
the MIN position.
The steam-shot function has
been used too often within a
very short period. The iron is
not hot enough.
The temperature knob has
been set to MIN.
The iron is not hot enough.
Water is over the max mark.
Steam holes are blocked.
Little or no water in tank.
Not enough pressure or air
inside.
Solution
Set the temperature knob to
the correct position.
Continue ironing in horizontal
position and wait a few
minutes before using the
vertical steam shot function
again.
Set the temperature knob
correctly.
Wait until the red-light
indicator turns red.
Empty the remaining water.
Clean the openings with
distilled water.
Add water to tank.
Press the spray nozzle
manually and press the spray
button several times in a row.