JANE CONCORD iGRADE Manual De Instrucciones página 31

_ 1 Use for children from 40 to 105 cm
Setting up the iGRADE for use from 40 to 105 cm
• To save space, in its original packaging, the iGRADE safety seat comes set up in the
rearward facing position and with the anti-rotation leg folded.
• Unfold the anti-rotation leg and pull it forward. (1a) will now be ready for use.
_ Installing the safety seat in the car
• Pull the two ISOFIX anchors (5) fully out by pressing the buttons on each anchor (5a) and sliding
them out. (1b)
• In some cars, the ISOFIX anchors are difficult to access or are hidden between the vehicle seat
foam. With the chair we provide you with some guides (15) to facilitate its location, insert them
before the next step.
• Guide the anchors towards the axles in your car and press until both sides both sides are locked,
two green signals displayed on both buttons (5b) or two green lights on the control panel will
indicate that they are locked. If one or both the signals are red, try again. (1c)
• Press the base (3) against the backrest of the vehicle seat until it is held firmly in place. (1d)
• Release the leg height lock by pressing the buttons (4a). Extend the leg until it touches the floor of
the vehicle. Lift the safety seat until the buttons (4a) lock again, the green signal will be displayed
on the base of the leg (4c) or on the control panel (4b). (1e)
EN
29