JANE CONCORD iGRADE Manual De Instrucciones página 34

Idiomas disponibles

_ Removing the seat when installed using ISOFIX:

• Release the ISOFIX anchors by pressing both ISOFIX buttons (5a). The signals on the

ISOFIX buttons (5b) will turn red.

• Remove the seat. Press the ISOFIX anchors (5) to store them inside the base.

_ 2 Use for children from 100 to 150 cm using the car seat belt

_Changing the safety seat into a booster seat with backrest

To switch the iGRADE safety seat into a booster seat with backrest, the seat must be in the

forward facing position. To complete the following steps the seat must be uninstalled from

the car.

• Rotate the leg by about 45 degrees. (5a)

• Press the leg support towards the base until it is fully inserted. (5b)

• Adjust the length of the leg to the shortest position by releasing the leg lock using the

buttons (4b).

• Rotate the leg towards the base until it fits into the slot. There is a lock that prevents it

from coming out. (5c)

• Fully loosen the belts by pressing the lock. (7b) (5d)

• Remove the fabric protector cover from the buckle. Lift up the backrest skirt and remove

the buckle from its slot. Refasten the belts to the buckle.