JANE CONCORD iGRADE Manual De Instrucciones página 37

_ Placing the child in the seat
• Position the child in the booster seat and pass the vehicle shoulder belt through the guide on
the side of the headrest (13). Pass the seat belt over the child and fasten the buckle. (7b)
• Lastly, pass the seat belts through the slots under both armrests. (13). (7c)
When you get the child out of the booster seat it is not necessary to take the seat belt out of the
guide at the side of the headrest (13), this makes it easier to fasten the child in the next time the
booster seat is used.
IMPORTANT : Even when the booster seat is not in use it should be secured with
the seat belt; in the event of sudden braking or an accident it could get flung about
and injure the other occupants of the vehicle.
_ Removing the seat when it has been installed with ISOFIX:
• Release the ISOFIX anchors by pulling both ISOFIX buttons (5). The signals on the ISOFIX
buttons (5b) will turn red.
• Remove the seat. Press the ISOFIX anchors (5) to store them inside the base.
_ 3 Reclining the seat
The iGRADE seat is reclined using a lever found underneath the feet (9). It has 5 positions.
This action, when the seat is used as a booster seat with backrest, requires the vehicle 3-point
seat belt to be adjusted, in this case it should be carried out while the vehicle is stationary.
EN
35