Intended Use - Stanley STEL401 Manual De Instrucciones

12 • ENGLISH
c. Disconnect the plug from the power source and/or
the battery pack from the power tool before
making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power
tool. Power tools are dangerous in the hands
of untrained users.
e. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the power
tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
5. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
6. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main
voltage corresponds to the voltage on the rating
plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
STANLEY Service Center or an equally
qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally
qualified person, but not authorized by
STANLEY, the warranty will not be valid.
7. Labels on tool
The label on your tool may include the following
symbols:
Hz .......
Read
Instructions
W ........
Manual
min .....
Use Eye
Protection
Use Ear
Protection
V ........ Volts
n .......
0
A ........ Amperes
Hertz
...... Class II
Watts
....
minutes
..... Alternating
....
Current
..... Direct
.../min..
Current
No-Load
Speed
FEATURES (FIG. A)
1. On/off switch
2. Dustbag
3. Dust extraction outlet
4. Sanding base
5. Paper clamp lever

INTENDED USE

Your Stanley sander has been designed for sanding wood,
metal, plastics and painted surfaces.
f Hold the power tool by insulated gripping
surfaces, because the sanding belt / sanding base
may contact its own cord. Cutting a "live" wire may
make exposed metal parts of the power tool "live" and
shock the operator.
f Use clamps or another practical way to secure
and support the work piece to a stable platform.
Holding the work by hand or against your body leaves
it unstable and may lead to loss of control.
Warning! Contact with or inhalation of dust arising
f
from sanding applications may endanger the health of
the operator and possible bystanders. Wear a
dust mask specifically designed for protection against
dust and fumes and ensure that persons within or
entering the work area are also protected.
f Thoroughly remove all dust after sanding.
f Take special care when sanding paint which is
possibly lead based or when sanding some woods
and metal which may produce toxic dust:
- Do not let children or pregnant women enter the
work area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris
safely.
f This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children should be
Construction supervised to ensure that they do not play with the
Earthing appliance.
Terminal
f The intended use is described in this instruction
Safety Alert
manual. The use of any accessory or attachment
Symbol
or performance of any operation with this tool other
Revolutions
or Recipro-
than those recommended in this instruction manual
cation per
minute
may present a risk of personal injury and/or damage
to property.
ADDITIONAL POWER TOOL
SAFETY WARNINGS