After Use - Stanley Fatmax SFMEE500 Traducción De Las Instrucciones Originales

Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN60745
and may be used for comparing one tool with another.
The declared vibration emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
:
The following pictograms along with the date code are shown
on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear ear protectors with impact drills. Exposure
to noise can cause hearing loss.
Wear safety glasses or goggles.
Wear a dust mask.
Electrical safety
#
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised STANLEY FAT MAX
Service Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Round sanding head
2. Round sanding pad (hook & loop system)
3. Motor housing
4. Folding lock
5. Main handle
(Original instructions)
6. Shaft
7. On/ Off switch
8. Electronic speed control wheel
9. Dust extration outlet (with locking sleeve)
10. Extension shaft
10a. Rear handle
10b. Dust extraction outlet (with locking sleeve)
10c. Sleeve
11. Vacuum hose
11a. Support adaptor
11b. Connector (pre-assembled) (38mm)
11c. Suction power adjustment ring
11d. Vacuum adaptor (pre-assembled) (47mm)
12. Vacuum adaptor (pre-assembled) (35mm)
13. Hex wrench
14. Round sanding disc
Use
Warning! Let the tool work at its own pace.
Do not overload.
Before using the tool for the first time, it is recommended
u
to receive practical information.
Always check that the supply voltage is the same as the
u
voltage indicated on the nameplate of the tool.
Use suitable detectors to find hidden utility lines or
u
call the local utility company for assistance(contact with
electric lines can lead to fire or electrical shock; damaging
a gas line can result in an explosion; penetrating a water
pipe will cause property damage or an electrical shock).
Do not work materials containing asbestos (asbestos is
u
considered carcinogenic).
Dust from material such as paint containing lead, some
u
wood species, minerals and metal may be harmful
(contact with or inhalation of the dust may cause allergic
reactions and/or respiratory diseases to the operator
or bystanders); wear a dust mask and work with a dust
extraction device when connectable.
Certain kinds of dust are classified as carcinogenic (such
u
as oak and beech dust) especially in conjunction with
additives for wood conditioning; wear a dust mask and
work with a dust extraction device when connectable.
Follow the dust-related national requirements for the
u
materials you want to work with.
Do not clamp the tool in a vice.
u
Use completely unrolled and safe extension cords with a
u
capacity of 16 Amps.

After use

After switching off the tool, never stop the rotation of the
u
accessory by a lateral force applied against it.
ENGLISH
9