Product Description; Components; Functional Description; Hazardous Areas And Safety Equipment - Ivoclar Vivadent Ivomat IP3 Instrucciones De Uso

3. Product Description

3.1 Components

The IVOMAT IP3 consists of the following components:
– Apparatus with air filter control
– Non-return valve
– 1.5 m compressed air hose
– 1.2 m water drain hose with canister cap
– Canister hose with sound absorber; polymerization
container in pressure chamber, and 3 object clips
secured to removable lid
– 1 return water container
– 1 replenishing cup
Special accessories
– IVOMAT refill container type IN 1
– Wallfixator

3.2 Functional description

The pressure chamber is equipped with a heater.
In this way, the water can be heated to the temperature
required for the corresponding material.
The pressure chamber is impinged with compressed air
to achieve optimum homogeneity of the material. The
polymerization time can be set by means of the timer.

3.3 Hazardous areas and safety equipment

Description of the hazardous areas:
Hazardous area
Safety holder
Air vents
Description of the safety equipment
Safety equipment
Protective conductor
IP44 (system of protection) Protection from electrical shock
Protective thermal switch
Type of risk
Electrical shock
Electrical shock
Protective effect
Protection from electrical shock
Protects the IVOMAT IP3
from overheating

4. Installation

4.1 Unpacking and checking the contents

Remove the apparatus from its packaging and check for
possible transportation damage. We recommend keeping
the original packaging for future transportation
purposes. Use only the original packaging for
transportation.
Do not carry the IVOMAT IP3 by means of
the power cord. Support the bottom of the
IVOMAT IP3 with both hands to carry it.

4.2 Selecting the location

Place the apparatus on a flat table using the rubber feet.
Make sure that the apparatus is not placed in the
immediate vicinity of heaters or other sources of heat.
Furthermore, protect the apparatus from direct sunlight.

4.3 Connections

Make sure the voltage indicated on the rating plate
complies with the local power supply. If this is not the
case, the apparatus must not be connected.
Connecting the compressed air hose
Make sure that the hose is properly connected.
Power connection
Make sure that the power cord does not touch any parts
of the apparatus that become hot during use.
The electrical installations of the room where
the apparatus is located must comply with
the national regulations and IEC standards.
8