AEG GDG961AL Manual De Instrucciones página 65

Function
Third speed / Boost function
3
4
AutoSense
Breeze
5
6
Light colour temperature
7
Lamp
8 WiFi indicator
9
Automatic cool down
10
AutoSense filter notification
Filter notification
11
3. DAILY USE
3.1 Using the hood - manual mode
Check the recommended speed according to
the table below.
While heating up food, cooking with covered
pots.
While cooking with covered pots on multiple
cooking zones or burners, gentle frying.
While boiling and frying big quantities of food
without a lid, cooking on multiple cooking
zones or burners.
While boiling and frying big quantities of food
without a lid, big humidity. After 8 minutes the
appliance returns to previous setting.
Refreshes the air in kitchen after cooking at a
very low noise level. The function turns off au‐
tomatically after 60 minutes. Use after cooking
only.
It is recommended to leave the hood
operating for approximately 15 minutes
before and after cooking.
Activating the appliance
To operate the hood:
Press the desired fan speed button.
Description
The motor switches to third speed level. Press and hold for 2 seconds
to activate the Boost function. Second press turns off the appliance.
Activates and deactivates the AutoSense function.
The hood operates on the lowest speed. After 60 minutes the motor
turns off.
Changes the light colour temperature.
Turns the lights on and off. Changes the light intensity.
Indicates WiFi connection status.
Indicates that the Automatic cool down is active.
Reminds to change or clean the AutoSense filter.
Reminds to change or clean the charcoal filter and clean the grease
filter.
Deactivating the appliance
To turn off the fan touch the activated speed
again or long press
Perfect Illumination - Lighting
The hood lighting works independently to
other hood functions.
Activating and deactivating the lighting
To illuminate the cooking surface press
button. Press the
the light intensity in the following order:
Maximum, Medium, Low, Off.
To switch off the lights, press and hold the
button for 3 seconds.
Setting the light colour temperature
The hood remembers the last setting of
the light intensity and colour temperature.
There are two ways to set the light colour
temperature:
.
button again to change
ENGLISH 65