Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION!
This function is sensitive to cleaning
agents. After cleaning, wait at least half
an hour before turning on the function to
avoid unintentional activation of the
Boost function.
When used with a gas hob, the function
may operate at higher speeds due to gas
combustion.
While preparing food that generates little
odour over an extended period (e.g.
simmering), the hood may stop and then
restart within a few seconds. If the hob
power level is very low, the generated
odour may not be sufficient for
AutoSense to function properly. If your
hood switches off and does not restart,
use manual mode to operate it.
To permanently deactivate the function:
1. Make sure the fan and the lighting are
turned off.
2. Press and hold the
and
indicators blink twice.
To activate the function again:
1. Make sure the fan and the lighting are
turned off.
2. Press and hold the
and
indicators blink once.
3.5 Automatic cool down
This function turns on automatically when the
temperature of the hood exceeds 70°C. The
hood continues to operate on the third speed
to cool down. The indicator with the symbol
on the panel turns on.
For safety reason, if the temperature
grows higher while the function is active,
the hood turns off and symbol
to blink. The hood can be turned on
again when the indicator stops blinking.
and
buttons.
and
buttons.
starts
3.6 Filter notification
The filter alarm serves as a reminder to clean
the grease filter and either replace or clean
the charcoal filter, depending on its type. The
indicator
and
seconds if the grease filter must be cleaned.
The indicator
and
second for 30 seconds if the charcoal filter
must be replaced or cleaned. Reset can be
performed during or out of the notification
period.
This function is activated after 40 hours
of the operation of the hood when the
grease filter requires cleaning and after
160 hours when the charcoal filter
requires cleaning or replacement.
Refer to cleaning the grease filter in Care
and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in Care and
cleaning chapter.
To reset the function counter:
For grease filter, press and hold
seconds.
For charcoal filter, press and hold
seconds.
The indicator stops blinking for the correct
reset in the notification period. The indicator
blinks once for correct reset out of the
notification period.
To activate or deactivate the filter
notification for charcoal filter:
1. Make sure the fan and the light are turned
off.
2. Press and hold
The function is activated if both indicators
blink once. The function is deactivated if both
indicators blink twice.
blinks regularly for 30
blinks twice per every
for 3
for 3
and
for 3 seconds.
ENGLISH
67
Publicidad
