AEG GDG961AL Manual De Instrucciones página 70

1
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
4.3 Replacing the charcoal filter -
optional
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Pull the tabs towards the bottom part of
the filter.
1
3. Slightly tilt the front of the filter
downwards, then pull.
4. To install a new filter, perform the steps in
the following order.
70 ENGLISH
1
2
Refer to the separate Installation
Instructions booklet.
4.4 Cleaning the AutoSense filter
The AutoSense filter must be cleaned
when the filter notification is on. Refer to
the "AutoSense filter notification" chapter.
To remove the filter:
1. Remove the grease filters from the
appliance.
Refer to the "Cleaning the grease filter"
chapter.
2. Turn the filter clockwise (1) and then pull
(2).
2
3. Wash the filter in hot water without using
detergent.
4. To install the filter back, perform the steps
in reverse order.
CAUTION!
The filter has to be fully dried before
installing it back into the appliance.
1