AEG GDG961AL Manual De Instrucciones página 69

If the onboarding process exceeds 1
minute, the control panel enters standby
mode, the indicator turns off, and the
app provides feedback on the onboarding
status.
If the onboarding process is unsuccessful, the
indicator flashes rapidly for 6 seconds and
then turns off. Repeat the procedure.
Each time the action is performed using
the app, the indicator blinks 3 times.
Disabling / Enabling the appliance
wireless connection
To temporarily disable the WiFi
connection, press and hold
4. CARE AND CLEANING
4.1 Notes on cleaning
Cleaning Agents
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth
with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To
avoid stains appliance must be cooled down and
dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Keep the hood clean
Clean the appliance and grease filters each month.
Clean the interior and grease filters carefully from fat.
Fat accumulation or other residue may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and
a short cycle. The grease filter may discolour, it has
no influence on the performance of the appliance.
Charcoal filter
The time of saturation of the charcoal filter varies de‐
pending on the type of cooking and the regularity of
cleaning the grease filter. Refer to leaflet included in
the accessory.
buttons. The
and the
To enable the WiFi connection again,
press and hold
indicators blink once.
Resetting the appliance wireless
connection
To offboard the WiFi network, press and hold
until the successful reset.
This action results in the removal of the
appliance from the WiFi network. To re-
establish the connection, repeat all the steps
described in the 'Configuring the appliance
wireless connection' section.
and
Before carrying out any maintenance,
make sure there is no cookware on the
hob and that the hood and the hob are
disconnected from the power supply.
4.2 Cleaning the grease filter
Filters are mounted with the use of clips and
pins on the opposite side.
To clean the filter:
1. Pull the cover to open it.
2. Pull the handle on the filter underneath
and
indicator turns off.
and
and buttons. The
the hood and slightly tilt the front of the
filter down.
indicators blink twice
buttons, and
indicator blinks
ENGLISH 69