Cebora GRV 12 Manual De Instrucciones página 4

Ocultar thumbs Ver también para GRV 12:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
INSTRUCTION MANUAL FOR COOLING UNIT
YOU ARE ADVISED TO READ THIS MANUAL, PAYING
PARTICULAR ATTENTION TO THE SAFETY REGULA-
TIONS, BEFORE INSTALLING, USING OR CARRYING
OUT ANY MAINTENANCE ON THE UNIT.
IF YOU DO NOT FULLY UNDERSTAND THESE
INSTRUCTIONS, CONTACT YOUR SUPPLIER.
1 SAFETY REGULATIONS
1.1 INTRODUCTION
Before use, all persons authorized to operate, repair or
inspect the unit must read the following safety and ope-
rating instructions.
Remember: YOUR SAFETY DEPENDS ON YOU !
The operator is responsible for his own safety, and for
that of other persons in the working area. He must the-
refore be aware of, and respect, all safety regulations.
NOTHING CAN REPLACE COMMON SENSE !
2 GENERAL DESCRIPTION
2.1 SPECIFICATIONS
This apparatus is a self-contained cooling unit, designed
to cool the torches used in TIG, MIG, MAG welding and
plasma cutting equipments.
2.2 EXPLANATION OF TECHNICAL DATA
2.3.2 "Coolant pressure" protection.
This protection is created by a pressure switch, fitted on
the coolant delivery circuit, which controls a microswitch
fitted.
N.B.: To use this protection, connector (E) must be inser-
ted in the welding or cutting generator's special socket.
4
Serial number
which
must
stated for any
demands relating
to the machine.
U1
Rated
supply
voltage.
1xV
Single-phase
power supply.
50/60 Hz Frequency.
I1
Maximum input
current .
IP23
Grade of protec-
tion of the body
2.3 DESCRIPTION OF PRO-
TECTIONS
2.3.1Electric protection.
The cooling unit is protected
against overload by means of
a fuse.
2.4 DESCRIPTION OF THE APPARATUS
A)
ON/OFF switch (I/O).
B)
Tank cap.
C)
Slot for checking the coolant level.
D)
Mains lead.
E)
"Coolant pressure" protection connector.
F)
Fuse holder.
G)
Quick fittings for the torch cooling hoses.
Cold water outlet. - Blue.
Hot water inlet. - Red.
H)
Quick fittings for the cooling hoses.
Cold water outlet. - Blue.
Hot water inlet. - Red.
G
D
A
be
3 INSTALLATION
3.1 SETTING UP
Place the apparatus according to the instructions given in
the manual of the machine with which it is to be used.
3.2 INSTALLATION
The unit must be installed by qualified personnel. All con-
nections effected must comply with the current stan-
dards and with the law on safety at work.
Before connecting up the mains lead, ensure that the
hoses are already connected, the power supply volta-
ge corresponds to that indicated on the technical data
plate, and the earth plug is efficient.
B
C
F
E
H

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1683Grv 141681

Tabla de contenido