Descargar Imprimir esta página

universalblue UBF2231-23 Manual De Instrucciones página 35

Frigo bajo encimera

Publicidad

Idiomas disponibles

Idiomas disponibles

• Do not use any cleaning product specific
for stainless steel on the outside of the
appliance.
Consider the following tips to clean the
inside of the appliance:
• Clean the inside of the appliance with
clean water or with a neutral cleaning
product. Then dry with a dry cloth.
• Clean the door gaskets thouroughly
• All accessories must be hand washed,
do not put them in the dishwasher.
• Rinse with clear water and dry with a
cloth.
Concerning the outside of the appliance,
remove the dust with a dry cloth and clean
it with a neutral cleaner if necessary.
When you have finished cleaning leave it
open for a short period of time to prevent
mold and bad odours..
• Electronic components, such as the on/
off button, should be cleaned with a dry
cloth.
• Cleaning agents such as soap powder,
abrasive cleaners, alkaline cleaners,
chemical
wipes,
petroleum products and hot water
should not be used to clean the fridge,
as they may damage the painted cover
and plastics.
Disconnecting the appliance
Power failure
After a blackout, the appliance can store
food for several hours, even if it is summer.
To avoid cold loss, we advise you to
consider the following notes.
• Do not more food than recommended in
the appliance.
• Do not open the door frequently.
If you disconnect the appliance
from the power supply, please
allow at least 5 minutes to pass
before reconnecting it
thinners,
alcohol,
.
Defrost
Water stored in the food or the air entering
the refrigerator door opening can form
a layer of ice inside. This will reduce the
level of cooling when the layer is thick.
When this layer is more than 2mm thick,
you should proceed to thawing.
Notes:
It is not recommended to heat
the freezer chamber directly with hot
water or use a hair dryer while defrosting
to prevent deformation inside it. It is
not recommended to scrape the ice or
separated from containers that were frozen
food directly using sharp objects or wooden
bars, to avoid damaging the interior of the
chamber or the surface of the vaporizer
food.
You can start defrosting by pressing the
central button on "Temperature Knob"
button, this will stop the compressor.
Remember to press it again to start the
appliance again.
The detailed instructions are made for
different refrigerator/freezer models. This
information may not apply to the model
purchased.
Maintenance of the led lamps
The appliance user cannot
replace the LED light. If it has
been damaged or does not
switch on, please contact the
supplier.
Any replacement or maintenance of the
LED lamps is intended to be made by the
manufacturer. Its service agent or similar
qualified person.
TROUBLE SHOOTING
EN
35

Publicidad

loading