How To Make Cappuccino - Oster OEMP50 Manual De Instrucciones

7. Once you have prepared the desired amount of espresso or cappuccino, switch the
power button to the off position "O" and unplug the unit. Allow the unit to cool down
before removing parts and accessories prior to cleaning.
8. After the unit has cooled down, remove the brew basket from the brew head. Using the
retainer clip to secure the filter in the filter holder, turn the brew basket upside down to
empty. Rinse the filter and brew basket with water.
9. If you wish to brew additional espresso, repeat the process. Turn the side knob to the
off position " ", remove the demitasses or jar from under the brew basket and place
new and empty ones. Carefully remove the brew basket by holding it with the handle,
ensuring to use the filter retention clip to hold the filter and dispose of the grounds. Put
fresh coffee in the filter, place the brew basket back underneath the brew head and
follow the instructions to brew coffee again (items 3, 5 and 6 from this section).
CAUTION: The metal parts of the brew basket might still be very hot. Make sure to
use the filter retainer clip when discarding the grounds. Cool these parts
by running under cold water.
10.For cleaning instructions, refer to Page 8.
Cappuccino is espresso topped with steamed and frothed milk. Frothing milk for cap-
puccino takes practice. Do not be discouraged if it is not perfect the first time. The milk
should be half steamed (bottom of pitcher) and half froth (top of pitcher). It may take a
few times before you perfect this process.
For best results, we recommend frothing the milk in a separate pitcher and pouring the
milk into your coffee. The milk and pitcher should be cold. Do not use a pitcher, which has
just been washed in warm water. We also recommend a stainless steel frothing pitcher
and a beverage thermometer, if you own one, for preparing the best froth and steamed
milk.
1. The first step in making cappuccino is to make espresso. Therefore, fill the water
reservoir with cold water. Never use warm or hot water to fill the water reservoir.
2. Follow steps 1 – 6 in the "Brewing Espresso" section.
3. Fill a small stainless steel or ceramic pitcher 1/2 full with cold milk and set next to
machine. Skim or 2% milk will be the easiest to froth.
4. You are now ready to froth and steam your milk. Press the red switch to the on
position "I", wait until the ready light "
the frothing tube so that the tip of the frothing tube is slightly immersed in the milk,
press the steam button "
becomes solid green again turn the side knob clockwise to the steam position "
Gently move the pitcher in a circular motion around the steam nozzle for about 50
seconds (for 4oz, of milk) or longer if warmer milk is desired. REMEMBER: The
milk and the pitcher should be very cold prior to frothing.
5. When the milk has doubled in volume, or, if you are using a beverage thermometer,
when the milk has reached 38°C (100°F), insert the frothing aid deeper into the milk
to further heat the milk. Do not heat milk above 65°C (150°F). To avoid splattering of
hot milk, do not let the tip of the frothing tube go above the surface of the milk. After
frothing is completed, turn the control knob back to the off position " ". The steam
" " and the brew "
light and the steam light turn off.

HOW TO MAKE CAPPUCCINO

". The ready light "
" lights will flash. The pump will run intermittently until the brew
" becomes solid green. Hold the pitcher under
" will start blinking and once it

".