Problems And Causes - Oster OEMP50 Manual De Instrucciones

PROBLEM
Coffee does • No water in reservoir.
not come out • Coffee grind is too fine.
• Too much coffee in the filter.
• Appliance was not turned on
• Coffee has been tamped/
Coffee comes • Filter holder not rotated
out around
the edge of the • Coffee grounds around the filter
filter holder
• Too much coffee in the filter basket.
No steam is • Water reservoir is empty.
generated
• Appliance is not turned on.
• Frothing tube is blocked.
Milk is not • Ran out of steam.
foamy after
frothing
• Milk is not cold enough.
Coffee comes • Ground coffee is too coarse.
out too quickly • Not enough coffee in filter basket.

PROBlEMS AND CAUSES

CAUSES
or plugged in.
compressed too much.
to full lock position.
basket rim.
• Add water.
• Grind coffee medium ground.
• Fill filter with less coffee.
• Plug unit into electrical outlet.
Turn it on.
• Refill filter basket with coffee
DO NOT TAMP.
• Rotate filter holder to full lock
position.
• Wipe off rim.
• Fill with less coffee.
• Fill reservoir with correct
amount of water. See Page 5
and 6.
• Turn on unit and follow the
operating instructions.
• Following frothing stage,
operate frothing function for
1 – 2 seconds to extract
excess milk. Or, turn off unit,
allow unit to cool, unplug
unit and clean out frothing
tube with a needle or
toothpick.
• Ensure there is enough water
in the reservoir.
• Chill milk and frothing pitcher
prior to making cappuccino.
• Use a finer grind.
• Use more coffee.
0
SOLUTIONS