OMFB RADAR II Manual De Instalacion Y Uso página 27

"RADAR II"
1. G
eneral Comments
1.1 OMFB RADAR II Radio remote control systems
OMFB radio remote control systems have been developed specifically for use on automotive
vehicles, thus taking into consideration the specific problems of automotive applications.
Special care was taken with the following factors:
• defining the type of housing to use;
• configuration of the manual commands always available in case of radio transmission
failure;
• radio channel engineering to ensure the proper capacity in terms of distance and transmitting
conditions.
The OMFB RADAR II radio remote control system essentially consists of the following components:
• 3 receivers:
1. 2-channel receiver (2 CH)
2. 2-channel receiver, trailer configuration (2CH RIM)
3. 4-channel receiver (4 CH)
• 2 transmitters:
1. RADAR II Midi transmitter (to control 2- and 4-channel systems)
2. RADAR NEW TXF transmitter (to control 2- to 12-channel systems)
The OMFB RADAR II system is completely modular, and up to 10 different configurations may be
obtained by combining the above components appropriately.
Each paragraph of this section describes the individual system components of the RADAR II radio
remote control system.
1.2 RADAR II 2-channel receiver
Emergency
Button
Manual control
buttons
USER MANUAL
pag.27
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it
Start Button
101050