Publicidad
Idiomas disponibles
Idiomas disponibles
"RADAR II"
3.2 RADAR II Receiver apparatus
SUPPLY VOLTAGE
MAXIMUM CURRENT CONSUMPTION
MAXIMUM SWITCHABLE CURRENT
WORKING FREQUENCY
RF SENSITIVITY
PASS-BAND
INTERFERENCE REJECTION
RF EMISSION TO ANTENNA
REACTION TIME
OUTPUTS
CURRENT CARRYING CAPACITY
TEMPERATURA DI FUNZIONAMENTO
4. e
leCtriCal sPeCifiCations
4.1 Power supply
RADAR II radio remote controls may be powered with a voltage between 10V and 28V
in direct current.
The power supply line (+12/24V batt and ground) should lead to the receiver directly from
the main source (battery or stabilized power source), with cables adequately sized for the
load to be carried (cross-section of at least 1 mm^2), also using a safety fuse.
The power supply line to the receiver must be kept locked, or under a switch dedicated
specifically to the radio remote control system, or under an appropriately sized battery
disconnector.
It is essential that the radio remote control system never be powered while the
vehicle is running: the installer is responsible for informing the system end user
of this fact.
USER MANUAL
pag.35
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it
min 9 V, max 28 V
370 mA a 10 V
563 mA a 28 V
8 A
433,920 MHz
- 100 dBm
600kHz a - 3dB
- 120 dB
- 80 dBm
2,5 seconds
N° 3 unstable relay type
max 8 A
- 30 / + 80 °C
101050
Publicidad
