Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
4. OPERATION
Fig. 6
-
Lift or gently press the fan head to adjust the fan tilt.
-
Connect the power cable to the power port on the base and plug the power adapter to a
power socket.
-
You will hear a beep indicating that the appliance is in Standby.
Please note:
-
Place the appliance on a horizontal, stable, and dry surface. Do not place the appliance on
unstable surfaces. If there is a slope or the surface is soft, take care to avoid damage to
the fan.
-
Avoid blocking the air inlet during use of the fan. Keep the appliance away from curtains.
The fan will not work if an object blocks the air inlet.
-
Do not place objects within 30 cm in front of the air outlet.
Control-panel functions
When the fan is in Standby, press this icon to start operation.
When the fan is running, press this icon to stop operation and enter Standby
mode.
Note: hold down this icon for 5 seconds to enable the Wi-Fi connection: the
indicator will flash.
Press this icon to change modes: Automatic mode, Strong Breeze mode, Sleep
mode, Natural Breeze mode, Manual speed.
Automatic mode: "
" is shown and air quantity is controlled by the PM2.5 value
detected. The Air Quality indicator light will light up based on the following values:
PM2.5
0-35
Speed
01
Display colour
Green
Strong Breeze Mode indicator: "
Sleep mode indicator: "
", lowest speed setting.
Natural Breeze Mode indicator: "
28
TOTALPURE 2IN1 MOONSTYLE/DARK
36-70
71-120
121-999
03
05
09
Yellow
Orange
Red
", maximum speed setting.
", alternating speed setting (3-4-5).
Press this icon to set the operating time from 1 to 8 hours.
If you unplug the fan from the power supply, the timer setting will be restored
upon reconnection.
Press this button to change the rotation angle: 30º, 60º, 90º, 120º, cancel.
Press this icon to change speed the: 1-9.
Note: hold down this icon for 2 seconds to switch to Strong Breeze mode.
The fan beeps every time you press an icon.
Using the remote
Press this button to turn the fan on or make it enter Standby mode. Hold it down
for 5 seconds to reset the filter usage time.
Press this button to change modes: Automatic mode, Strong Breeze mode, Sleep
mode, Natural Breeze mode, Manual speed.
Press this button to enable or disable rotation (90º by default).
Press this button to change the rotation angle: 30º, 60º, 90º, 120º.
Press this icon to change speed the: 1-9.
Press this button to turn off or activate the display.
Press these buttons to adjust the air volume: 1-9.
Press this button to turn the light under the control panel on or off.
The fan beeps every time you press a button on the remote.
Using the remote. Fig. 7
Remove the insulating film before first use.
When using the remote, point it at the fan's control-panel display.
Replacing the battery. Fig. 8
-
Release the side tab.
-
Pull down and remove the battery holder.
-
When inserting the battery, press the "+" pole upwards.
-
Reinstall the battery holder in the remote.
ENGLISH
TOTALPURE 2IN1 MOONSTYLE/DARK
29
Publicidad
