golmar Stadio Plus Manual De Instalación página 107

106
P
rogramming the telephones.
In case of a general entrance door panel, program the telephones only from each internal
building door panel, as described on the corresponding instruction manual.
If this door panel is installed on an internal building of a residential complex or on a single
building, program the telephones as follows:
golmar
For T-940 Plus:
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
TELEPHONES PROGRAMMING
13:15
To enter the door panel into program mode, press
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
With the door release push button pressed
switch on the telephone.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message
release push button can be released. Lift the handset
to stablish audio communication with the door panel.
key symbol and enter the installer PIN code
(factory default: 1315), as described on page 83.
. At this moment, the door
program mode
Enter the code that will be used to call to
this telephone and press the bell key.
At this moment the panel will reproduce
a sound and the telephone led will blink.
To program the telephone as master,
switch it off and on again.
To program it as slave, press the door
release push button.
To program it as slave with intercom
function press the center push button.