NODOR NorCook IH N8205 BK Manual De Instrucciones página 29

cooking for a short period of time. All cookware will stop receiving power and all timers and alarms
are stopped, just for the duration of the pause.
To activate this function, press key (3) for at least 1 second. All of the keys will remain disabled except
the lock key (4) and the On/Off key (1).
To cancel this function, press key (3) for at least 1 second. The pause icon will flash. Then, press any
other key within 10 seconds, otherwise the hob will switch off. All cooking processes will be resumed
at the same point they were when the pause function was activated. The cookware will be reheated
to the same power level and the timers will be reactivated. Only the Nboost+ and Nfastup functions
are cancelled after the pause.
Nlimit: Operating time limitation (F8)
This safety function turns the heat off if an unusually long period of time has passed since the control
was last used. This time (L) depends on the selected power level (P).
See values in the F8 chart, where:
P is the selected power level.
L is the maximum operating time, in hours.
Each new action on the control of the cookware restarts the countdown to this time limit.
Nkey: Protects from continuous key pressing
This safety function is intended to protect the hob from prolonged and unintentional key pressing.
Pressing any key for more than 10 seconds will activate the error message "Er03" on the display (10)
and turn off the control.
When the key is no longer being pressed, this error message will disappear, and the control can be
turned on again.
Note: Liquid spilled on the control area will not always activate this function.
Ntime: Timer for cookware
This function allows you to automatically programme the end of the cooking time for a piece of
cookware. Each piece of cookware has its own stand-alone timer. Several timers for several pieces
of cookware can be running at once. You can select the time you require within a range of 1 to 99
minutes. The remaining time is shown on the display (5) alternately with the power level.
To activate this function, the cookware must be in use (power > 0). Press the display (5) designated
to the piece of cookware and select the time using the slider (2). First you must select the units and
then the tens. In each case, the value will automatically be set 2 seconds after the last time it was
touched. The countdown begins and the selected time value is shown on the display (5) for 5 seconds
and then the power value is shown again. The remaining time will be shown on the display (5) every
25 seconds for 5 seconds. For each piece of cookware with an active timer, an LED lights up next to
the display (5). To change an active timer, press key (5).
When the timer reaches its last minute, the remaining seconds are shown on the display (5).
If the timer is set to 0, then it will be cancelled without interrupting the cooking process.
When the timer ends, the display (5) flashes 00 and an acoustic signal is emitted. The end of the timer
will be confirmed, and the acoustic signal can be stopped by pressing any key, or after 2 minutes.
To cancel this function, press and hold key (5) for 2 seconds.
Stopping a piece of cookware's cooking process will also cancel the designated timer.
60819630.20.07.2020.indd 29 60819630.20.07.2020.indd 29 1/10/20 10:22 1/10/20 10:22