NODOR NorCook IH N8205 BK Manual De Instrucciones página 30

Nwarn: Reminder
This function allows you to set a reminder that will sound at the end of the time set. This does not
impact any cooking processes that are underway, it is only an acoustic signal. You can select the time
you require within a range of 1 to 99 minutes.
To activate this function, press key (6) and select the time using the slider (2) on the front left side.
First you must select the units and then the tens. In each case, the value will automatically be set 2
seconds after the last time it was touched. The time selected is shown on the display (10) and the
countdown begins. When it reaches its last minute, the remaining seconds are shown on the display
(10). To change the reminder time press key (6).
When the timer for the reminder ends, the display (10) flashes 00 and an acoustic signal is emitted.
The end of the timer will be confirmed, and the acoustic signal can be stopped by pressing any key,
or after 2 minutes.
To cancel this function, press and hold key (6) for 2 seconds.
Conflicting positioning of cookware
There are 3 types of conflicts:
1. Power conflict
This induction hob comprises 12 inductors. A conflict arises when several pieces of cookware with
different power requirements are placed on the same inductor.
Symbol (9) and the display (5) are allocated to the piece of cookware with the highest power level
flash for 8 seconds.
To resolve the conflict, perform one of the following actions within 8 seconds:
- Move one of the pieces of cookware.
- Reduce the power level of the piece of cookware with the highest power level.
- Remove or turn off one of pieces of cookware.
If no action is taken, after 8 seconds the highest power level will automatically decrease.
Once solved, symbol (9) turns off and the display (5) remains in place.
2. Positioning conflict
This occurs when the system is not able to determine the exact position of a piece of cookware.
An acoustic signal is emitted. Symbol (9) flashes. A light sequence begins (from the centre to the
ends) on the slider (2) of the piece of cookware that has caused the conflict.
To resolve the conflict, perform one of the following actions:
-If the piece of cookware was already on the hob before pressing the ON/OFF key (1), then lift it for
2 seconds and put it back.
-Move the cookware.
-Remove the cookware.
Once solved, symbol (9) turns off and the display (5) and slider (2) remain in place. All the initial pa-
rameters (power level, timer) are restored.
3. Allocation conflict
Each piece of cookware can only have one unique control element. Likewise, each control element
can only be assigned to one piece of cookware.
60819630.20.07.2020.indd 30 60819630.20.07.2020.indd 30 1/10/20 10:22 1/10/20 10:22