NODOR NorCook IH N8205 BK Manual De Instrucciones página 33

U8 Full power limi-
tation
Maintenance (F4)
Pieces of aluminium foil or food, fat splashes, spilt sugar or highly sugared foodstuffs should be
removed immediately from the cooking surface using a spatula to avoid scratching the hob surface.
Subsequently clean the surface with a suitable product and kitchen roll, rinse with water and dry
with a clean cloth. Never use abrasive sponges or scourers and avoid the use of aggressive chemical
detergents or stain removers.
Installation (F5) (F6) (F7)
Instructions for the fitter
All operations relating to installation must be carried out by qualified personnel in line
with current regulations.
The appliance is designed for fitting into a worktop, as shown in the figure. Place the supplied sealant
around the perimeter of the hob. The hob should not be installed over an oven, although if this is the
case, check that:
- The oven is equipped with an appropriate cooling system
- There is no warm-air leakage from the oven towards the hob.
- Suitable air inlets are provided as shown in the figure.
Selection of installation equipment
- Cut out the work surface according to the sizes shown in the drawing. (F6)
- For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the
hole.
- Be sure the thickness of the work surface is at least 15mm.
- Under any circumstances, make sure the induction hob is well ventilated and the air inlet and
outlet are not blocked. (F5)
- Stretch out the supplied installation joint along the underside edge of the hob, ensuring the ends
overlap.
- Do not use adhesive to fix the hob into the worktop.
- Place the hob into the cutout in the worktop (F7). Apply gentle pressure downwards onto the hob
until it is fitted, ensuring a good seal around the outer edge.
Before you install the hob, make sure that
• The work surface is level and made of a heat-resistant material. Also, the walls near the hob must
be heat-resistant.
• The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the hob electronics.
• The installation will comply with all clearance requirements and applicable standards and reg-
ulations.
When you have installed the hob, make sure that
• The power supply cable is not accessible through cupboard doors or drawers.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier is in-
stalled below the base of the hob.
60819630.20.07.2020.indd 33 60819630.20.07.2020.indd 33
-- --: Unlimited
2-.0-5.0 with incre- Examples:
ments of 0.1kW
2.1: Power limited to 2.1kW
5.0-10.0 with incre-
ments of 0.5kW
5.5: Power limited to 5.5kW
1/10/20 10:22 1/10/20 10:22