OPERATION (CONTINUED)
Upper Hook
Latch
Frame
Load Chain
Lower Hook Block
Latch
Lower Hook
Do not take up the load chain to the point where the chain stop
or lower hook block becomes jammed against the frame.
Handwheel
Directional Lever
Selector Lever
Handle
Chain Stop
ATTACHING THE LOAD
Attach the lower hook to the load so that it is seated in the bowl
of the hook and is not bearing against the tip of the hook or latch,
and the latch is tight against the hook tip.
Allowing the load to bear against the hook latch and/or hook tip
can result in loss of load.
TO AVOID INJURY:
Do not allow the load to bear against the hook latch and/or hook
tip. Apply load to hook bowl or saddle only.
Do not wrap the chain around the load and hook onto itself as a
choker chain sling or bring the load in contact with the hoist. Doing
this will result in the loss of the swivel effect of the hook which could
cause twisted chain and a jammed liftwheel. Also, the chain may be
damaged at the hook. Make sure the upper and lower hooks are in a
straight line and the frame is free to swivel on the upper hook.
Figure 3B
TO PULL OR LIFT THE LOAD
While holding the load end of the chain, rotate the hand wheel
clockwise, as shown in Figure 3B.
Move directional lever to the load position. Operate lever in up and
down motion to lift the load.
When pulling or lifting, move the load only enough to slightly load
the unit, then check to be sure that the attachments to the hooks
and load are rmly seated. Continue movement only after you are
assured the load is free of all obstructions.
The hoist has been designed for hand powered operation only. Do
not use an extension on the lever. Any pull force greater than 46.5
lbf (21 kgf) for the 0.75 Tonne unit, 60 lbf (27 kgf) for the 1.5 Tonne,
86 lbf (39 kgf) for 3 Tonne, and 99 lbf (45 kgf) for 6 Tonne unit is an
indication of either an overload or an incorrectly maintained unit.
7
(ENGLISH)
Figure 3B - Tornado360 Manual
P/N: 192034281 Rev AE Sept 2018