Publicidad
Idiomas disponibles
Idiomas disponibles
920-007-11 (8-05)
How to usethe remote control
J!i
f
f
{ J_rJedrich
gn_
Speed
s_ver_
J
Figure
3
To start unit
@
POWER - Press the POWER button once. The unit
will automatically start in the mode and fan speed it
was last left on.
To set mode of operation
©
©
®
COOL - Press the COOL button to automatically switch
the operating mode to COOL.
FAN ONLY - Press the FAN ONLY button if you want
to run the tim only.
MoneySaveff _- Press the MoneySaver °°button to activate
the MoneySaveff )feature. MoneySaver ®is the feature that
cycles the fan with the compressor so that the fan does
not run all the time.
To adjust temperature
@
WARMER - Press the TEMP _t_
button to raise the
temperature setting.
@
COOLER - Press the TEMP '_'
button to lower the
temperature setting.
To adjust fan speed
FAN SPEED - Press the FAN SPEED button to see the
current setting. Press again to change the tim speed. FI
is the lowest setting (SLEEP / LOW), F2 is MEDIUM,
F3 is HIGH, and SF is the SMART FAN setting.
To set the hour clock
®
SET HOUR CLOCK - Press SET HOUR once to see
the current clock setting. Continue pressing the button
until you arrive at the current time (Hour only). Minutes
are not shown on the display. Make sure that the A.M.
/ RM. setting is correct.
To set the timer
NOTE: You can set the START and STOP times a minilnum
of one hour apart, and a maximum of 23 hours apart.
@
TIMER START- Press START to view the current start
•
(y
time tBrcooling. Continue press11_ the START butto 1
until you arrive at the start time you desire. The start
time tbr cooling will then be set.
®
TIMER STOP - Press the STOP button.
Continue
pressing the STOP button until you arrive at the stop
time you desire. The stop time tbr cooling will then be
set.
TIMER ON/OFF-
Press the TIMER ON / OFF button
to activate (light on) or deactivate (light off) the timer.
Once the on and off times have been selected, they will
remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the
SET HOUR function must be reset or the TIMER ON / OFF
function will not work.
Additional RCI wireless remote controls can be purchased
from your Friedrich dealer.
Publicidad
