Audi 8V3.071.126 Instrucciones De Montaje página 33

4.1.2 Installing the rear roof bar — for vehicles
with „bright moulding package" (4ZB)
– Carefully guide the assembly tool -14- into the area of door
between the decorative trim and window rubber.
– Push the assembly tool -14- carefully to the rear and align
with the arrows -Y- in the side window.
● The assembly tool -14- must be positioned between the ar-
rows -Y- in the side window.
– Pull the assembly tool -14- downwards and hold it in this po-
sition.
– Unhook the claw fastener -12- from the installation position
on the support bracket- 9- by pulling upward, then swivel
down.
– Carefully insert the claw fastener -12- between the assembly
tool -14- and the decorative roof trim and push it in as far as
it will go.
● The claw fastener -12- must be positioned between the ar-
rows -Y- in the side window.
Installation instructions - Audi A3 (8V3) 2012 ▶
4 Installing/removing roof bars on vehicle
Edition 06.2012
11