Audi 8V3.071.126 Instrucciones De Montaje página 34

Installation instructions - Audi A3 (8V3) 2012 ▶
Edition 06.2012
– Hold the claw fastener -12- in the installation position and
gently tighten the bolts -13- using the torque wrench -15-.
– Remove the assembly tool -14- and follow the same proce-
dure on the opposite side.
– Tighten the roof bars
— for vehicles with „bright moulding package" (4ZB) and ve-
hicles with „black moulding package" (4ZE)" on page
4.1.3 Installing the rear roof bar — for vehicles
with „black moulding package" (4ZE)
– Using your fingers, fold down the side window rubber be-
tween the arrows -Y- in the side window and hold it in this
position.
– Unhook the claw fastener -12- from the installation position
on the support bracket- 9- by pulling upward, then swivel
down.
– Carefully insert the claw fastener -12- between the side win-
dow rubber and the sidewall frame and push it in as far as it
will go.
● The claw fastener -12- must be positioned between the ar-
rows -Y- in the side window.
– Let go of the side window rubber.
12
4 Installing/removing roof bars on vehicle
⇒ „ Securing the front and rear roof bars
13.