Publicidad
Idiomas disponibles
Idiomas disponibles
4.3
Removing the roof bars from the vehi-
cle
– Remove the load and the add-on components.
– Open the lock -17- using the key -18- and open the cover
flap -16-.
– Open the vehicle doors.
– Unscrew the left and right tensioning bolts -13- alternately
using the torque wrench -15- until obvious resistance is felt.
– Pull the claw fasteners -12- at the left and right of the front
roof bar downward as far as they will go. The positioning
bolts should no longer be in the mounting holes.
– Swivel the claw fasteners -12- on the front roof bar upwards
and hook the „narrow ends" into the installation position on
the support bracket -9-.
– Remove the front roof bar from the vehicle roof.
– Pull the claw fasteners -12- on the rear roof bar out of the
sidewall frame on the left and right-hand sides.
– Swivel the claw fasteners -12- on the rear roof bar upwards
and hook the „narrow ends" into the installation position on
the support bracket -9-.
– Remove the rear roof bar from the vehicle roof.
– Unhook the claw fasteners -12- from the installation position
and swivel downward.
– Screw in the tensioning bolt -13- by approx. 10 rotations.
– Close the cover flap -16- and lock the lock with the key.
4.4
General notes
Technical data
Weight of roof bar set: approx. 6 kg (13 lbs).
Roof load/load
To determine the roof load:
Weight of the roof bars
+
Weight of the add-on component
+
The weight of the load
=
Roof load
Installation instructions - Audi A3 (8V3) 2012 ▶
4 Installing/removing roof bars on vehicle
Edition 06.2012
15
Publicidad
