Dalbach GS60V-0B Manual página 39

4 Putting the appliance into operation
Before putting the appliance into operation, make the following settings and fill the
appliance with regenerating salt, rinsing agent and dishwasher detergent.
4.1 Setting the water hardness
Before putting the appliance into operation for the first time, adjust it once to the local
water hardness. You can obtain this information from the water supplier or on the
Internet.
The water softener serves to remove minerals and salts from the water that could
•
damage the appliance or have an undesirable effect on the dishes.
The more minerals and salts your water contains, the harder the water.
•
The dishwasher is designed so that the amount of salt used can be adjusted according to
the hardness of the water used. This is to optimise and individually adjust salt
consumption.
8. Open the door and switch on the appliance.
9. Press and hold the "Short program" button for slightly longer than 5 seconds
within 60 seconds of switching on the appliance
10. The display shows the saved water hardness.
11. Use the "Short program" button to select the required water hardness
H3>H4>H5>H6>H1>H2.
12. No operation in 5 seconds or press "On/Off" button and save the selected water
hardness.
Carry out the settings using the following table
Factory setting: H3
WATER HARDNESS
ºdH ºfH ºClark ºmmol/l
0~5 0~9 0~6
6~11 10~20 7~14
12~17 21~30 15~21
18-22 31-40 22-28
23~34 41~60 29~42
35~55 61~98 43~69
1° dH = 1.25° Clark = 1.78 °fH = 0.178 mmol/l
° dH: German hardness ° Clark: British hardness ° fH: French hardness
*) Regeneration of the water softening system
4
Display
H1
0~0.94
H2
1.0~2.0
H3
2.1~3.0
H4
3.1~4.0
H5
4.1~6.0
H6
6.2~9.8
Putting the appliance into operation
Salt
consumption
(gr./cycle)
0
9
12
20
30
60
Regenerate
all X program
runs *)
NO
10
5
3
2
1
Seite | 39