Dalbach GS60V-0B Manual página 49

7 Decommissioning the appliance
Observe the sequence of the work steps:
54. Pull out the mains plug or switch off the fuse for the plug socket.
55. Turn off the water tap.
56. Loosen the inlet and outlet hose.
57. Loosen fixing screws from the worktop, if present.
58. Remove the base board, if present.
59. Pull out the appliance, carefully pulling out the hoses at the same time.
Allow remaining water to drain from the hose
If the sink is 1000 mm or more from the floor, the remaining water cannot run out
directly into the sink.
In this case, collect the remaining water from the hose in a suitable vessel outside the
sink.
Transport
 Empty the appliance and secure loose parts.
 Transport the appliance only upright (so that no remaining water can run into the
machine controller and cause programme errors).
8 Faults
Before you contact after-sales service
FAULT
Appliance is not
working.
Dishes are not dry or
not properly dry
8
POSSIBLE CAUSE
Fuse blown or fused circuit-
breaker tripped.
Plug is not plugged in to the
plug socket.
Low water pressure
Appliance door does not
close properly.
No rinsing agent used or
dosage set too low
Dishwasher detergent used
has poor drying capacity
Selected programme has no
"Dry" function
The "Extra dry" function was
REMEDY
Check fuses.
Plug the mains plug into the
plug socket.
Check whether the water
supply hose is correctly
connected and the tap is
properly turned on.
Close the appliance door.
3. Fill with rinsing agent
4. Regulate rinsing agent
quantity
Use rinsing agent or combined
detergent with higher drying
capacity
Select programme with "Dry"
Activate the "Extra dry"
Faults
Seite | 49