Publicidad
Idiomas disponibles
Idiomas disponibles
BV 9800
BEFORE FIRST USE
1. Please read all instructions carefully and keep for future reference.
2. Remove all packaging.
3. Place the carafe on the base and clean it following the instructions in the CLEANING section. Dry it and
reassemble it.
4. Clean the base with a soft cloth. Do not immerse the base in water or other liquid. Do not use abrasive
cleaners.
GENERAL USE
1. Place the mixer on a clean, flat, dry and stable surface.
2. NEVER start the blender when the jar is empty.
3. Add ingredients to jar and secure lid before placing jar on base. Unless the directions say otherwise, add
the liquid ingredients first, then the solids. Always add ice and large, hard ingredients last. Make sure
the cap is closed by turning it clockwise. ATTENTION: when adding hot liquids be careful not to splash
and leave it in the jug without the lid for a few minutes to allow the steam to escape.
4. Plug the mixer into an earthed socket. NEVER attempt to place carafe on or remove carafe from base
while motor is running.
5. Turn mixer on and slowly increase speed to desired speed. The jar may move a little while the motor is
running. Let the mixer run until the preparation reaches the desired consistency.
6. If the contents do not move, DO NOT MOVE the jar while the motor is running. Use the PULSE function
or the mixer stick:
7. Activate the PULSE function as many times as necessary
8. Remove the cap and insert the stick through the hole in the cap. Hold the jar with one hand while with
the other you use the pusher to unlock the contents of the jar.
9. If this doesn't work, turn the power button OFF to stop it. Once the blades have stopped, remove the
jug from the base and stir the contents with a rubber spatula. Replace the jug on the base and put the
lid and stopper back in place to reconnect the blender.
10. When you are done, turn the power button to the OFF position. ATTENTION: the blades can cause
severe injuries. Before removing the jug or emptying it, wait until the blades stop.
11. Unplug from power and remove carafe from base. ATTENTION: the motor gear, blade nut and blades
may be very hot after use, do not touch them and wait for them to cool down.
BLENDING DRY INGREDIENTS
- Always review all the general use instruction above.
- DO NOT operate the blender continuously for more than 90 seconds when processing dry ingredients.
- When chopping nuts or other dry mixtures, ensure even chopping by adding more than enough
ingredients to cover the blades.
USE OF THE BLENDER WITH HOT LIQUIDS
- Always review the general use section when using the mixer.
- WARNING: be careful when filling the carafe with hot liquids, you could burn yourself from the
splashes.
- Let the hot liquids sit in the jar uncovered for a while, allowing the steam to escape, before
beginning to blend.
17
Publicidad
