Publicidad
Important Safety Instructions
Do not disassemble.
•
Keep out of the reach of children. The product contains small parts which may be a choking hazard.
•
The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
•
Do not use the product in environments with too high or too low temperatures, and never
•
expose the product to strong sunshine or very wet environments.
Ensure there is no liquid, sweat or water on the charging port when charging.
•
Refer to your user manual for your earphones' waterproof level and follow the corresponding
•
instructions.
￮ For IPX4: Do not expose earphones to dripping or splashing water.
￮ For IPX4, IPX5, and IPX6: Do not submerge earphones in water.
Hearing Safety
To avoid hearing damage, do not listen for extended periods at high volume.
•
Do not turn the volume so high that you're unable to hear your surroundings.
•
Do not use earphones while driving.
•
You should use caution or temporarily discontinue use in potentially hazardous situations.
•
The product generates stronger permanent magnetic fields that could cause
interference with cardiac pacemakers, implanted defibrillators (ICDs) and other
implants. Always maintain a distance of at least 3.94"/10 cm between the product
component containing the magnet (earbuds and charging case) and the cardiac
pacemaker, implanted defibrillator, or other implant.
Notice
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at
the following internet address: https://www.soundcore.com.
Maximum output power: 9.0dBm
Frequency band: 2.4G band (2.402GHz-2.480GHz)
01 EN
This symbol means the product must not be discarded as household waste, and
should be delivered to an appropriate collection facility for recycling. Follow local
rules and never dispose of the product and rechargeable batteries with normal
household waste. Correct disposal of old products and rechargeable batteries helps
prevent negative consequences for the environment and human health.
This symbol indicates "separate collection" for all batteries and accumulators. Danger
of explosion if battery is incorrectly replaced. To reduce risk of fire, explosion or leakage
of flammable liquid/gas, don't disassemble, crush, puncture, short external contacts,
expose to temperature above 60°C (140°F), sunshine or like, expose to extremely low
air pressure or dispose of in fire or water. Replace only with specified batteries.
High or low extreme temperatures that a battery can be subjected to during use, storage or
transportation:
• During use: maximum 40℃ (104°F)
• Storage: -20 - 45℃ (-4 - 113°F)
• Transportation: 5 - 35℃ (41 - 95°F)
FCC Statement
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
EN 02
Publicidad
