Publicidad
Idiomas disponibles
Idiomas disponibles
Your appliance should be used as a portable appliance only (paying attention to all the safety
warnings given below)
1. Put the heater on a flat, dry and clean surface.
2. Install the rollers as shown on the image below
Warning: Always use your appliance with fixed rollers.
• Leave a minimum distance of 1 m between any side of your appliance and any obstacle
(furniture or walls, for example) to allow a good circulation of the airflow.
• Always direct the airflow in order to optimise the heating of the room.
• Avoid the corners, small spaces, wood floors, ceiling, etc...
• INDOOR USE ONLY!
1. Display for Temperature/Timer/Heating
power
2. Mode selection/Temperature setting/Timer
setting/Heating power setting
3. Eco mode
4. Power on/off
How to use:
• Plug the appliance in to an AC 220-240V 50/60Hz socket
• To start the heater, press the ON/OFF switch
• Turn +/- to set the temperature from 5–35°C. When the temperature is set lower than 5°C,
the screen will display that the heater is working in anti-frost mode.
• To set the power, press MODE, turn +/- to select the power from H1-H2-H3: H1 is for low
power (I), H2 is for medium power (II), H3 is for high power (I + II). After setting the power,
press MODE to confirm or wait for three seconds.
• To set the timer (timer off), press MODE for three seconds. The screen will display a flash-
ing H, select the timer from 1-24, press MODE to confirm or wait for three seconds.
• ECO mode. Press ECO to set the eco mode. If the target temperature is 20°C, the small
number on the display will change to E.
• Press ON/OFF switch to turn off the heater.
• Unplug the product when it is not in use.
INSTALLATION
DISPLAY SCREEN AND CONTROL PANEL
1
2
3
4
E NGLI SH
7
Publicidad
